Chevre Starter Instructions

You will need:

stainless steel pot with lid
non-aluminum spoon
thermometer
butter muslin, tight-weave dish towel, or yogurt bag
colander
bowl
raw or pasteurized goat milk (avoid ultra-pasteurized or UHT)
1 packet Chevre starter culture (store remaining packets in freezer for future use)
non-iodized salt

 

Directions:

1) Slowly heat (on low) 1-4 quarts of milk to 86 degrees F. (heat the milk no faster than 1 degree per minute- this can take 30-40 minutes for a gallon).

2) Add one packet of Chevre starter and mix thoroughly, using an up-and-down motion rather than a stirring motion. Mix no longer than 15 seconds.

3) Place the lid on the pot and allow to culture in a warm spot, 72 to 77 degrees F., for 12 hours.

4) The Chevre should be set after 12 hours. There may be some separation of the whey-this is normal. Place the colander in a bowl & line the colander with a double layer of butter muslin or dish towel. Spoon the cheese curds into the colander, gather up the corners of the cloth, and tie them together to make a bag (a yogurt bag can also be used).

5) Hang the Chevre-filled bag over a bowl to drain the whey for 6-12 hours (the whey can be reserved for other uses).

6) Store your finished Chevre in a closed container in the refrigerator for about a week. If freezing, remove as much whey as possible and salt well first.

Now it’s time to Get Fermented!

Download instructions here.

0